Start / Stop Cleaning; Charge Your Robovac - EUFY RoboVac 30 Manuel D'utilisation

English
Remove objects within 3 ft/1 m of the left and right side and within 6 ft/2 m of the
front of the Charging Base.
Connect the round connector of the adapter into the power socket on the Charging
Base and the other end into a wall outlet.
• When the Charging Base connects to AC power, the LED indicator on the
Charging Base is SOLID WHITE.

Charge Your RoboVac

• RoboVac has a pre-installed rechargeable battery that has to be fully charged before
use.
• RoboVac returns to the Charging Base at the end of a cleaning cycle or when its
battery is running low.
Method 1: Attach RoboVac to the Charging Base by aligning its charging pins with the
charging pins on the base.
12
- Install the Charging Base in a location that RoboVac - Install the Charging Base in a location that RoboVac
can easily access. It is recommended to place the
T can easily access. It is recommended to place the
Charging Base against a wall, and on a hard-level
Charging Base against a wall, and on a hard-level
surface rather than on rugs or carpets. surface rather than on rugs or carpets.
- Always keep the Charging Base plugged in, otherwise
- Always keep the Charging Base plugged in, otherwise
RoboVac will not automatically return to it. RoboVac will not automatically return to it.
Method 2: Press on the remote control to return RoboVac to the Charging Base.
Turn off the main power switch if RoboVac will not be used for a long period of
time. To preserve the battery's lifespan, recharge at least once every 6 months.

Start / Stop Cleaning

Make sure the main power switch on the bottom of RoboVac is turned on before use.
1. Press on RoboVac or / on the remote control to start cleaning in Auto Mode.
2. Press on RoboVac or on the remote control to stop cleaning.
English
13