EIBENSTOCK EBM 352/3 Notice Originale page 30

In Case of Malfunction
In case of breakdown, switch the machine off and
disconnect the plug from the mains. Repairs on the
electric parts of the tool may only be done by an electric
specialist.
Trouble Shooting
Error
machine does not
work
motor runs, drill bit
does not rotate
drilling speed too
slow
motor cuts off
water drops out of
the gearbox housing
Possible Cause
mains current supply interrupted
line cord or plug damaged
switch damaged
the PRCD-switch is off
Gear not engaged properly or
accidentally disengaged
gearbox damaged
drill bit damaged
A too high water flow rate
prevents self-sharpening of the
drill bit
drill bit is blunt
the tool stops
the tool overheats, overload
protection of the motor has
reacted
carbon brushes are worn out -
auto-stop brush switch off
shaft sealing rings damaged
Error Recovery
plug in another electric
appliance and check the
functioning
have it checked by an electric
specialist and replaced if
necessary
have it checked by an electric
specialist and replaced if
necessary
press RESET to switch on
Operate the gear switch to
engage the required gear
have the tool repaired by an
authorised service workshop
check if drill bit is damaged and
replace it if necessary
regulate the water quantity
sharpen the drill bit with a
sharpening block while using
the flush
lead the tool in a straight
manner
discharge the tool and restart it
by pressing the switch a couple
of times
both brushes must be replaced
with original brushes by an
electrical specialist
have the tool repaired by an
authorised service workshop
30