EIBENSTOCK EBM 352/3 Notice Originale page 117

Fixing the Core Drill Motor
Caution! When mounting the machine, risk of squashing.
Wear protective gloves!
Setting up the mounting plate
For the operation of the core drill, its operating instructions and safety
advices have to be strictly observed!
In order to operate the tool safely, please observe the following notes:
Details of the work area
Keep the work area free of everything which could obstruct operations.
Provide for adequate illumination of the work area.
Adhere to the regulations concerning the power connection.
Move the machine holder upwards until it locks
in the top position.
Use the turnstile to open the locking device of
the mounting plate.
Remove it and connect it to the core drill motor
as described subsequently.
The tool is supplied with a mounting plate,
a 10 mm fitting key and 4 Allen screws M8x20.
The mounting plate is put on in such a way with
the fitting key on the machine that the socket is
in the mounting plate on the same side as the
gear switch of the machine. Afterwards the four
screws are insert and tightened firmly.
Insert the core drill with the attached mounting
plate into the drill rig and lock it with the turnstile.
Operations
17