Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Regarding the air entry and the air vent
After a long time of use, some dust or other dirt may be accumulated at the air entry or air
vent. Use a flexible brush or a detergent to clean it. The body of the appliance can be
cleaned with caution with a dry cloth.
Note: never immerse the induction cooker in the water and do not maintain it with
a steam cleaner.
b) Troubleshooting
Here are the recommended inspections of common failures:
Problems
After the plug in the socket, the indicator (1) and
the screen do not light up.
The button (1) lights up but heating does not
Heating stops suddenly during operation.
Failure
codes
start.
E0
E1
E2
E3
E4
E5
E6
E1-E3-E4
E0-E2-E5-E6
Points to check
- Make sure that the plug is inserted tightly.
- Make sure that the switch, socket, fuse and
power line are in good condition.
- Make sure that the containers are suitable for
induction cooker.
- Sent it to service facility to repair
- Let the appliance cool down
- Let air entry and air vent free
- Set again the timing
- Refer to failure codes
- Inner circuit error
- No pan or the pan is not suitable
- IGBT is overheat
- Input volt is too high
- Input volt is too low
- Heat sensor 1 open or short circuit
- Heat sensor 2 open or short circuit
- Please inspect by self before sending to repair
- Please contact the customer care service (see your
warranty card for Toll Free number)
28
Publicité
Table des Matières
Dépannage
