Minor Troubleshooting; Cooking - Brandt TI302BS1 Guide D'utilisation Et D'installation

Minor troubleshooting

You have doubts about whether your hob is working correctly .... ...... this does not
necessarily mean there is a breakdown. Nevertheless, check the following points
IF YOU REALIZE THAT
When you switch on, the display lights up
When you switch on, the fuse blows
The fan keeps going for a few minutes after the hob
has been switched off
The top of the hob is always warm (even when it is
switched off).
The hob does not work. Displays on the key-
board do not come on
The hob does not work, another message comes
on
After having turned on a heating zone, the keyboard
displays continue to flash.
The pans make a noise during cooking
The hob gives off a smell when first used for

cooking

If the slightest break or crack appears in the ceramic glass surface, disconnect the
unit immediately and contact your After Sales Service.
POSSIBLE
CAUSES
The hob is working normally
Your hob is connected incorrectly
The electronics are cooling down
The electronics are under power as for
all other electronic apparatus (TV,
transformers, etc.).
The apparatus is not under power.
There is a power or connection problem.
The electronic circuit is working badly.
The saucepan you use is unsuitable for
induction cooking or its diameter is
under 12 cm. (10 cm on the 160 mm
zone).
This comes from vibrations made by
energy going from the hob to the pan.
A new apparatus
11
WHAT SHOULD
YOU DO?
Check the connection and make sure it
complies with requirements.
This is normal.
This is normal.
Inspect the fuses and the cut-out
switch.
Call the After Sales Service
See containers.
Under high power this phenomenon is
normal with certain types of pans. There
is no danger for the hob.
Use each heating zone for ½ hour
with a pan full of water.