Troubleshooting - Brandt TI1FSOFT Manuel D'instruction

b) Troubleshooting
Here are the recommended inspections of common failures:
Problems
After the plug in the socket, the indicator
(1) and the screen do not light up.
The button (1) lights up but heating does
not start.
Heating stops suddenly during operation.
Failure
codes
- Inner circuit error
E0
- No pan or the pan is not suitable
E1
E2 - IGBT is overheat
E3 - Input volt is too high
E4 - Input volt is too low
E5 - Heat sensor 1 open or short circuit
E6 - Heat sensor 2 open or short circuit
E1-E3-E4 Please inspect by self before sending to repair
Please contact the customer care service (see
E0-E2-E5-E6
your warranty card for Toll Free number)
27
Points to check
- Make sure that the plug is inserted
tightly. - Make sure that the switch,
socket, fuse and power line are in good
condition.
- Make sure that the containers are
suitable for induction cooker.
- Sent it to service facility to repair
- Let the appliance cool down
- Let air entry and air vent
free - Set again the timing
- Refer to failure codes