Table des Matières
Publicité
Glue
The outer elements should be glued with the acrylic
which is included. Make sure that all the surfaces that
are to be glued are free of dust. The surfaces can be
cleaned for better adhesion. Ensure that the surfaces
are dry before spreading on the acrylic. Once the
fireplace is assembled, fill the joints with acrylic and
even it out with a sponge or finger and some soapy
water, in order to have a clear indentation between the
elements (FIG Z).
Minor Dents
Transportation and handling can cause minor dents to
the product. This can be repaired with the powder glue
which is included. For a perfect result you can fill and
grind with a suitable filler on top of the powder glue.
Fill smaller cracks and uneven surfaces with a float or
a brush. If the dent is deep, it is recommended to fill in
several stages to avoid sinking. Even out with e.g. a
damp sponge or a float.
Painting
The surface of the chimney surround is developed to be
painted without priming work. Use latex or acrylic based
paint (emulsion paint), or cement-based textured paint.
In the unlikely case that there are some irregularities in
the surface, these can be filled with the acrylic which is
included, or a light and appropriate filling material. Any
surface that has been filled needs to be smoothened
with fine sand paper.
Tiles
The stove may also be partially or completely covered
with tiles or natural stone of your choice. Prior to fixing
the tiles or natural stones we recommend that the stove
is dampened and covered with tile glue and fiber mesh.
Please note that the adhesive and mortar must
set before burning in the fireplace. Follow the
instructions from the mortar/adhesive producers.
Regardless of surface treatment it is advantageous to
mask the entire door frame to avoid having to clean it
later.
Please note that the air gap between the surround
and the door frame must not be filled with glue,
mortar or similar.
Thermotte™
The insulation plates (Thermotte) are classified as "wear
and tear" parts which will require to be exchanged after
some years. The wear time will depend on the individual
use of your product.
Nordpeis offers a one-year warranty on these parts.
After this, replacements can be purchased.
Please note: Wood logs that are too long can cause
additional strain and crack the plates, due to the tension
created between the side plates.
4
Cracks in the i PowerStone
Due to thermal effects there may be small cracks /
fissures in the PowerStone. This is natural and does not
affect the product's function or safety.
2. Warranty
Use replacement parts recommended only by
the Manufacturer.
Any unauthorized modification of the appliance
without written permission of the Manufacturer
are prohibited.
For detailed description of the warranty conditions see
the enclosed warranty card or visit our website
www.nordpeis.com
Recycling of the refractory glass
Refractory glass cannot be recycled. Old glass,
breakage or otherwise unusable refractory glass, must
be discarded as residual waste. Refractory glass has a
higher melting temperature, and can therefore not be
recycled together with glass. In case it would be mixed
with ordinary glass, it would damage the raw material
and could, in worst case end the recycling of glass. It is
an important contribution to the environment to ensure
that refractory glass does not end up with the recycling
of ordinary glass.
CERAMIC GLASS
CANNOT BE
RECYCLED
Ceramic glass should
be disposed of as resid-
ual waste, together with
pottery and porcelain
Packaging Recycle
The packaging accompanying the product should be
recycled according to national regulations.
Door and Glass
Should there be any soot on the glass it may be
necessary to clean it.
other detergents may damage the glass/gaskets. (NB!
Be careful, even dedicated glass cleaner can damage
the varnish on the door frame and
advice for cleaning the glass is to use a damp cloth or
kitchen roll paper and apply some ash from the burn
chamber. Rub around the ash on the glass and finish off
with a piece of clean and damp kitchen roll paper. NB!
Only clean when the glass is cold.
GB
Warning!
Warning!
Use dedicated glass cleaner, as
gaskets).
A good
Publicité
Table des Matières
