Disassembly; Maintenance - Vermeiren 2030 Mode D'emploi

Diagram for the transformer connections (the transformer is located below the mattress
support platform on the head section):
3.4

Disassembly

1. Lower the nursing bed to the lowest horizontal position.
2. Lock at least 2 castors by using the brakes.
3. Remove the lifting pole.
4. Remove the side rails.
5. Remove the plug of the power cable out the supply socket.
6. Disconnect all cables out the transformer.
7. Lift the mattress support platform out the grooves of the head- and footboard.
8. Loosen the star knobs of the headrest and slide the headrest section out the leg
section.
4

Maintenance

For the maintenance manual of the beds refer to the Vermeiren website:
www.vermeiren.com.
To be connected in the sequence indicated.
Port 1 = Motor head section
Port 2 = Motor headboard
Port 3 = Motor leg section
Port 4 = Motor footboard
Port 5 = Handset
Port 6 = Power supply
Power socket 220V/230V, 50 Hz
Not used
Page 18
2030
2017-05