Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
STUDER Innotec
ENGLISH DESCRIPTION
I
NTRODUCTION
The sine wave inverters of the AJ serie have
been
designed
domestic needs. They meet the highest
requirements in terms of comfort, safety and
reliability.
Any device designed for the public electrical
grid of 230 V 50 Hz can be connected to them
(up to the nominal power of the inverter).
The AJ series is the perfect source of voltage in
any place where the public grid is not
available.
This document is an essential part of the
inverter and must always be carried with it
and be available for anyone working on the
installation.
Should you have any doubt or question, do
not
hesitate
to
salesperson who will give you the best advice.
W
ARNING
A deficient assembly could result in damage
to the device, cause function failures or
potential damage to the users.
The working device generates a high voltage
which might be lethal in case of contact. So,
any manipulation of the inverter must be
carried out with utmost care and meet the
local rules.
THE OWNER MUST NOT MANIPULATE ANY PIECE
INSIDE THE INVERTER.
Opening the inverter or using it incorrectly will
result in the immediate loss of the warranty.
The inverter AJ is to be used only with a lead
battery. As for the use of batteries, follow the
manufacturer's instructions.
No current or voltage generating device
(public grid, generator, ...) may be connected
to the output of the inverter because this
could result into its destruction.
to
meet
industrial
contact
your
specialist
I
NSTALLATION
The AJ sine wave inverter is an electronic
and
device, for which some caution must be taken
when installing it:
Place where the inverter is to be installed:
Out of reach of unauthorized persons, espe-
cially children.
In a dry place (max. 95% humidity), and in any
case with no condensation.
Not directly on top of the batteries.
No easily inflammable material should be
placed directly underneath or close to the AJ.
Ventilation must be free, and a space of 10
cm. on each side is needed for good
evacuation of the internal heat.
Mounting the inverter
The inverter shall be mounted on a non
flammable surface by screws (diameter max.
4 mm for AJ 275-AJ 1300 or max. 8 mm for AJ
2100 and 2400) using the four holes provided.
The fixing screws are not supplied with the
inverter. It may be fixed into any position.
AJ V2.7
AJ
4/50
Publicité
Table des Matières
