Changing The Brake Fluid - Benelli 302S Manuel Du Propriétaire

Rear brake
1
Front brake fluid reservoir
Specified brake fluid:
DOT 4
WARNING
Improper maintenance can result in
loss of braking ability.
Observe these precautions:
• Insufficient brake fluid may allow
air to enter the brake system, re-
ducing braking performance.
• Clean the filler cap before remo-
ving. Use only DOT 4 brake fluid
from a sealed container.
• Use only the specified brake fluid;
otherwise, the rubber seals may
deteriorate, causing leakage.
• Refill with the same type of brake
fluid. Adding a brake fluid other
than DOT 4 may result in a harmful
chemical reaction.
• Be careful that water or dust does
not enter the brake fluid reservoir
when refilling. Water will signifi-
cantly lower the boiling point of
the fluid and may result in vapor
lock, and dirt may clog the ABS
hydraulic unit valves.
NOTICE
Brake fluid may damage painted surfa-
ces or plastic parts.
Always clean up spilled fluid immedia-
tely.
As the brake pads wear, it is normal for the
brake fluid level to gradually go down. A
low brake fluid level may indicate worn
brake pads and/or brake system leaka-
ge; therefore, be sure to check the brake
pads for wear and the brake system for
leakage. If the brake fluid level goes down
suddenly, have a Benelli dealer check the
cause before further riding.
6 - 21
Periodic maintenance and adjustment

Changing the brake fluid

Have a Benelli dealer change the brake
fluid at the intervals specified in the pe-
riodic maintenance and lubrication chart.
EN
6