Neutral Indicator Light; Digital Clock; Tachometer; Oil Pressure Warning Light - Benelli 302S Manuel Du Propriétaire

Instrument and control functions
Turn signal indicator lights "
" "
Each indicator light will flash when its cor-
responding turn signal lights are flashing.
EN
Neutral indicator light "N"
This indicator light comes on when the
3
transmission is in the neutral position.
High beam indicator light "
This indicator light comes on when the
high beam of the headlight is switched
on.

Oil pressure warning light "

This light switches on when the engine oil
pressure is low.
It is possible to check the electrical circuit
for the light by turning the key to " ".
Once the engine is running, the light
should switch off.
If the light does not switch on when the
key is turned to " " or if the light stays on,
get the electrical circuit checked by an au-
thorised Benelli centre.
" and
TIP
• Even if the oil level is sufficient, the
warning light may flicker when ri-
ding on a slope or during sudden
acceleration or deceleration, but this
is not a malfunction.
• If a problem is detected in the oil
level detection circuit, the oil level
warning light will flash repeatedly.
If this occurs, have a Benelli dealer
check the vehicle.
"
Engine trouble warning light "
This warning light comes on if a problem
is detected in the engine or other vehicle
control system. If this occurs, have a Be-
nelli dealer check the on-board diagnostic
"
system.
The electrical circuit of the warning light
can be checked by turning the key to " ".
The warning light should come on for a
few seconds, and then go off.
If the warning light does not come on ini-
tially when the key is turned to " ", or if
the warning light remains on, have a Be-
nelli dealer check the vehicle.

Tachometer

The tachometer shows the running tur-
nover of the engine so that the rider can
keep it within the ideal power range.
Coolant temperature
This shows the temperature of the coo-
lant.
The coolant temperature varies with chan-
ges in the weather and engine load. if the
"warning lamp" flashes, stop the vehicle
then stop the engine and let it cool.
"
Do not continue to operate the engine
if it is overheating.

Digital clock

Shows the time in hours and minutes.
3 - 4
WARNING