Fermax DUOX PLUS Manuel D'installation page 13

When mapping, the amplifi er saves the link between the natural call code (address) and the newly
assigned call code in a table.
There are 2 ways of carrying out mapping:
1. Inverse Programming.
If you need the buttons to generate non-sequential calling codes, like for codes that include fl oor
num. and house number.
2. Sequential Programming.
If you need a special distribution. On street panels you press the call buttons in the order in which
you want to associate the codes, starting with 0 and then sequentially until the last one.
Important notes:
• Programming is always done from the panel activated as MASTER.
• The panel must be previously confi gured as Master if you want to do inverse or sequential programming.
• In order to enter in any button mapping mode you must have the amplifi er in stand-by.
MASTER Panel:
• A street panel is confi gured as a MASTER via the SW1 amplifi er button. If the SW1 button is pressed 3 times quickly, it
is activated as a MASTER panel and a confi rmation tone sounds (beep-beep).
• When a panel is selected as MASTER, it notifi es the rest of the situation and if another was previously confi gured, it
would automatically stop being so.
• If there are various blocks in an installation, we recommend using the general entrance panel as MASTER since it allows
you to program all of its telephones.
• Once having completed the terminal´s confi guration, we recommend deactivating the MASTER panel to avoid accidentally
reprogramming terminals.
• The panel deactivates itself from master mode following the same activation procedure: 3 quick presses of the SW1
button. A deactivation tone sounds (beep-bop).
Amplifi er
SW1
DL2
5
DUOX PLUS