Filling The Rinse Aid Reservoir
1
Remove the rinse reservoir cap by
lifting up the handle .
3
Close the cap after all.
Adjusting the rinse aid reservoir
To achieve a better drying performance with limited rinse aid, the dishwasher is
designed to adjust the consumption by user. Follow the below steps.
1.
Open the door and s
2. Within 60 seconds after step 1, press the
and then press the Delay button to enter the set model, the rinse aid indication
blinks as 1Hz frequency.
3. Press the
Rapid
the sets will change in the following sequence: D1->D2->D3->D4->D5->D1.
The higher the number, the more rinse aid the dishwasher uses.
4. Without operation in 5 seconds or press the Power button to complete the setup
and exit the setup mode.
Rinse aid level
witch on the appliance.
button to select the proper set according to your using habits,
D1
D2
D3
D4
D5
2
Pour the rinse aid into the dispenser,
being careful not to overfill.
Rapid
button more than 5 seconds,
Selector position
Rapid Light bright
90min Light bright
90min, Rapid Light bright
Eco Light bright
Eco, Rapid Light bright
68