AYA ALVI1247FIX Manuel D'utilisation page 47

For detailed operating method read the corresponding content on the instruction manual.
Switch on the appliance
Fill the detergent dispenser
Check the rinse aid level
Check the regeneration
salt level
Load the baskets
Select a programme
Running the dishwasher
Changing the programme
Add forgotten dishes in
the dishwasher.
If the appliance is switched
off during a wash cycle.
Switch off the appliance
Turn off the water tap,
unload the baskets
Quick operation guide
Press the Power switch button to switch on the appliance, Open the door.
Open the flap(marked with A), fill in the main wash detergent , and then close the flap;
Pre wash detergent drop into the tank directly;
(Follow the user instructions!)
Refill the rinse aid through the hole below the cap(marked with B)
If you need .
(On models with water softener system only.)
Electric indicator on control panel (if provided).
If there is no salt warning light in the control panel
(for some models), you can estimate when to fill the salt into
the softener by the number of cycles the dishwasher has run.
Scrape off any large amount of leftover food. Soften remnants of burnt food in pans,
then load the baskets. Refer to the dishwasher loading instructions.
Close the door,press the program button to select the programs.
( See the section entitled"Operationg instruction")
T urn on the water tap and press the Start/Pause Button. The machine
will start working.
1. A running cycle can only be modified if it has been running for a short time.
Otherwise the detergent may have already been released drained.
If this is the case, the detergent dispenser must be refilled.
2. Press the Start/Pause button, Then press the program button more than 3 seconds to
cancel the running program.
3.Select a new programme.
4. Restart the dishwasher.
1.Press the Start/Pause Button to stop the machine.
2.Open the door .
3.Add forgotten dishes.
4.Close the door,Then Press the Start/Pause Button, the dishwasher will
run after 10 seconds.
If the appliance is switched off during a wash cycle, when switched
on again, please re-select the washing cycle and operate the dishwasher
according to the original Power-on state ).
When the working cycle has finished, the buzzer of the dishwasher will sound 8 times,
then stop.
Turn off the appliance using the ON/OFF button.
Since the appliance is standing by, it will power off automaticly after 30 minutes without
any operation.
Warning: wait a few minutes (about 15 minutes) before unloading the dishwasher to
avoid handling the dishes and utensils while they are still hot and more susceptible to
break.
They will also dry better.Unload the appliance, starting from the lower basket.
A A
B B
WARNING!
Open the door
carefully.
Hot steam may
escape when the
door is opened!