Bartscher PRO Plus 40T A190145 Mode D'emploi page 37

Descaling
ATTENTION!
In order to extend the use of the device and to ensure good quality coffee, the
coffee maker should be descaled regularly!
Claims will not be accepted if the coffee maker will not be descaled regularly,
as described in the instruction manual.
Such claims are not covered under the warranty!
o The device is equipped with red descaling indicator. Depending on the hardness of
used water the indicator may be activated after some brewing cycles, which indicates
that the device must be descaled. At the same time the overheating protection is
activated and the device is turned off.
o After descaling the coffee maker must be turned on only after pressing the RESET
button in the base. When the device is turned on after descaling, the indicator is not
activated.
o For descaling the device we recommend „Rapid descaler for coffee makers"
that we have tested.
Code-No.: 190065; packing unit: (30 bags 15 g each).
o Dissolve the content of the bag (15 g) in approximately 5 liters of water.
o Push the riser pipe through the center of the filter basket and place it in the water
container. Make sure that the riser pipe has been carefully inserted in the heating hole.
o Pour the descaling mixture into the water container of the coffee maker. Place the
cover on the water container and turn on the device.
o Start the brewing process and leave the coffee maker on for about 15 minutes.
o Turn off the device and drain the descaling mixture from the water container through
the faucet.
o After descaling, perform the brewing process at least three times to remove all
remnants of the descaling mixture.
o Rinse thoroughly with warm water the water container, riser pipe, filter basket and
drain this water through the faucet.
o The coffee maker is now ready for use.
WARNING!
Do not leave the coffee maker without supervision while descaling!
During descaling use gloves and goggles!
o After descaling carefully wash your hands.
- 34 -