VINCENT SV-500 Manuel D'utilisation page 36

CONNECTION OF THE LOUDSPEAKERS
If no connector is to be used, remove approxima-
tely 1 cm length of insulation from each end of the
speaker wire. Twist the braid in order to avoid
short circuits. Turn the fastener on the loudspeaker
terminal counter clockwise to loosen it and introdu-
ce the bare wire end into the exposed connector
hole. Then turn the fastener clockwise so that the
wire is firmly clamped. Make sure the connection
is pretty tight.
A set of headphones equipped with a 6.3 mm jack can be plugged into the socket "PHONES" (3) on the
front of the appliance.
SV-500
By doing this, the loudspeakers are switched off. All headphones with an impedance of between 32 Ohm
and 600 Ohm may be used. Unsuitable headphones with too low impedance may damage the amplifier
or produce such unexpectedly loud volume that your hearing may be damaged. The volume (8)(21) should
be reduced for safety reasons before a set of phones is connected.
CONNECTION OF THE POWER CABLE
Check that the electricity supply to your home is appropriate to the device. The required voltage and fre-
quency can be read on the back of the device beside the socket for the mains. If the electricity supply is
appropriate, push the inlet connector of the supplied mains cable firmly into socket for the mains on the
back of the device. Connect the other end of the mains cable to a mains socket.
This device is equipped with a switch (16) that can be used to change the country-specific voltage from
230 V to 110 V.
Please never actuate the switch during operation! The voltage must only be switched by a techni-
cian, since the device fuse must also be replaced after actuation of the switch! Information about
the device fuse can be found on the back of the device.
Unauthorised actuation of the switch will void any warranty claim!
Vincent
36
CONNECTION OF HEADPHONES
SWITCHING THE VOLTAGE