Operation - Ventilate - Bestron DFT45S Mode D'emploi

user's instructions
MontAGe - preparations for assembling
1. Unscrew the spinner from the motor-housing shaft (by turning it clockwise) and remove the spinner.
2. Unscrew the locking ring from the motor-housing (by turning it anticlockwise) and remove the ring from
the motor housing.
MontAGe - Assembling the fan
A
C
1. Fit the rear of the fan housing (B) onto the motor-housing, making sure that the openings are aligned
precisely with the lugs on the motor housing and that the grip is at the top.
2. Slide the locking ring onto the shaft, and screw it tight (clockwise).
3. Slide the fan blades onto the shaft, making sure that the notches are aligned precisely with the two
keys on the shaft.
4. Fit the spinner onto the shaft and tighten it (anticlockwise) whilst preventing the fan blades from
moving.
5. The rim has five clamps (A). Carefully fit the rim around the rear half of the fan housing, making sure
that the housing falls into the upper clamp of the rim, so that you can connect the two halfs of the fan
housing with the nut and bolt (C). Use a crosshead screwdriver to screw the bolt into the nut.
6. Close the other clamps.
7. Loosen the stand lock fitted to the rear of the control unit.
8. Fit the fan onto to the upright, and tighten the lock.

operAtion - Ventilate

1. Set the fan on the floor, on a level surface.
2. Adjust the stand to the required height, see Figure 4. Loosen the height lock (by turning it
anticlockwise). Adjust the stand to the required height and tighten the height lock (by turning it
clockwise).
B
Figure 4
Loosening the height lock
to adjust the height of the stand
19
D
C
Figure 3
Assembling the fan
Figure 5
Tilting the fan