Operation - Ventilate - Bestron AFS45RE Mode D'emploi

operAtion - Ventilate

1. Set the fan on the floor, on a level surface.
2. A djust the stand to the required height. To do so, loosen the height lock (anticlockwise). Adjust the
stand to the required height, and tighten the height lock (by turning it clockwise).
a
b
3. Tilt the fan to the required angle. You can set the fan:
a. t o blow horizontally (position a) or angled slightly downwards (position b). Tilt the ventilator housing
and motor housing to the required angle.
b. t o oscillate from left to right (with a sweep of 90°). This will ventilate much of the room. Press the
oscillation button on the motor housing fully in.
c. r emain in the same position whilst the fan is turning. This will ventilate one area. Pull out the
oscillation button until you hear it click.
4. Put the plug into the wall socket.
Figure 5
Loosening the height lock to adjust the height of the stand
Figure 7
Operating the fan
28
instruction manual
Figure 6
Tilting the fan