Turning Off the Power
1
Press the I /
1
"POWER OFF? Please press I / 1 key
again." appears to confirm that you want
to turn off the power.
Notes
A message disappears if you press any key
except the I / 1 key, or if you do not press
any key for five seconds.
2
Press the I /
1
The lens protector close and the powered
tilt adjuster is put away in the projector.
The ON/STANDBY indicator flashes in
green and the fan continues to run for
about 60 seconds to reduce the internal
heat. Also, the ON/STANDBY indicator
flashes quickly for the first 45 seconds.
During this time, you will not be able to
light up again the ON/STANDBY
indicator with the I / 1 key.
3
Unplug the AC power cord from the
wall outlet after the fan stops running
and the ON/STANDBY indicator
lights in red.
When you cannot confirm the on-
screen message
When you cannot confirm the on-screen
message in a certain condition, you can turn
off the power by holding the I/ 1 key for
about two seconds instead of steps 1 and 2.
Note
The internal circuitry of the Off & Go and
Direct Power On/Off functions may cause the
fan to continue to operate for a short time even
1
after the I /
key is pressed to turn off the
power and the ON/STANDBY indicator
changes to red.
22
GB
Projecting
key.
key again.