Sony VPL-CX80 Mode D'emploi page 33

• Adjust the items "Dot Phase," "H Size" and
"Shift" in the INPUT SETTING menu when
you adjust the picture manually.
1) The APA (Auto Pixel Alignment)
automatically adjusts "Dot Phase," "H Size"
and "Shift" in the INPUT SETTING menu
for the input signal from a computer.
Auto Input Search
Normally set to "Off."
When set to "On," the projector detects input
signals in the following order: Input-A/
Input-B/Video/S-Video. It indicates the
input channel when the power is turned on or
the INPUT key is pressed.
Input-A Signal Sel.
Selects the computer, component or video
GBR signal input from the INPUT A
connector.
Note
If the setting is not correct, the color of the
picture becomes strange or "Please check
Input-A Signal Sel." appears on the screen and
the picture is not displayed.
Color System
Selects the color system of the input signal.
If you select "Auto," the projector detects
the color system of the input signal
automatically. If the picture is distorted or
colorless, select the color system according
to the input signal.
When the color system of the input signal is
PAL60, select "PAL." If "Auto" is selected,
the color system cannot be detected.
Speaker
Set to "Off" to cut off the sound of the
internal speakers. When set to "Off,"
"Speaker: Off" appears on the screen when
you turn on the power.
Stand-by Mode
You can lower the power consumption in
standby mode.
Standard: Normally, select this position.
Low: Select this position when you want to
lower the power consumption in standby
mode.
Power Saving
When set to "On," the projector goes into
power saving mode if no signal is input for
10 minutes. Although the lamp goes out, the
cooling fan keeps running. The power
saving mode is canceled when a signal is
input or any key is pressed. In power saving
mode, any key does not function for the first
60 seconds after the lamp goes out.
IR Receiver
Selects the remote control detectors (IR
receiver) on the front and rear of the
projector.
Front&Rear: Activates both the front and
rear detectors.
Front: Activates the front detector only.
Rear: Activates the rear detector only.
Illumination
Selects whether the SONY logo on the top
panel of the projector lights when the
projector is on. Normally, this setting is
"On". If you want complete darkness or if
the illuminated logo is a distraction, change
this setting to "Off".
Panel Key Lock
Locks all the control panel keys on the top
and side panels of the projector so that the
projector can be operated only with the
Remote Commander.
To lock the control panel keys, set to "On."
When it is set to "On," keeping the I/1 key
on the control panel pressed for 10 seconds
turns the projector on when it is in standby
mode, and turns the projector to standby
mode when the power is on. If you keep
pressing the MENU key for about 10
seconds when the power is on, the lock will
The SET SETTING Menu
33
GB