Turning Off The Power - Sony VPL-CX236 Manuel De Référence Rapide

Automatically adjusts Phase, Pitch and Shift of projected image while a
signal is input from a computer (APA (Auto Pixel Alignment))
Press APA on the remote commander. Press again to cancel during the setting.
If Smart APA is set to On, executes APA automatically when a signal is input.

Turning Off the Power

1
Press the ?/1 key on the main unit or the Remote Commander.
The shutdown message appears.
If you do not press any of the keys for a while, the projector will turn off.
?/1
If you press on the projector or remote commander while the shutdown message is on
the screen, the projector will restart.
Note
Do not turn off the projector soon after the lamp lights. It may cause a malfunction of the lamp
(does not light ,etc.).
2
Unplug the AC power cord from the wall outlet.
After step 1, the fan continues to run for a while to reduce internal heat, however, you may
also unplug the AC power cord before the fan stops.
Turning off without displaying the confirmation message
?/1
Hold the key on the main unit pressed for a few seconds.
ECO gauge
This gauge indicates the current effectiveness of the projector's ECO function. (For details on
the ECO function, see "ECO MODE key", "AUTO POWER SAVING" and "Lamp Mode").
The leaf icons are displayed when the projector is shut down. The number of displayed icons
varies according to how much energy is saved as a result of using the ECO function.
ECO gauge
Projecting an Image
21
GB