KitchenAid KGCU407 Instructions D'installation page 17

6. Place LP gas orifice spuds in plastic parts bag for future use
and keep with package containing literature.
NOTE: There may be extra orifices in your kit.
7. Replace the burner base.
8. Replace burner cap.
9. Repeat steps 2 through 8 for the remaining burners.
To Convert Grill Burner (on some models)
1. Remove grill grate, wave plate, flame spreader and burner
assembly. See the "Install Grill Grease Trays" section for
removal instructions. Set parts aside.
2. Use a
/ " deep-well socket to remove the LP gas orifice
1
2
hood. Replace with correct grill Natural gas orifice hood.
See the "Natural Gas Orifice Spud/Hood Chart."
A
A. Grill orifice hood location
3. Turn Natural gas orifice hood down tightly onto orifice base.
4. Place LP gas orifice hoods in plastic parts bag for future use
and keep with package containing literature.
5. Before replacing the burner assembly, loosen the screw at
the front of the burner and rotate the shutter so that the
opening is / " (9.0 mm) wide.
3
8
A. Shutter opening
B. Screw
A
B
6. Reinstall the burner assembly, flame spreader, wave plate,
and grill grate. See the "Install Grill Grease Trays" section for
installation instructions.
7. Open shut-off valve in the gas supply line. The valve is open
when the handle is parallel to the gas pipe.
REMEMBER: Once you have completed converting the
grill, test the cooktop for leaks by brushing on an approved
noncorrosive leak-detection solution. Bubbles will show,
indicating a leak. Correct any leaks found.
8. Plug in cooktop or reconnect power.
Complete Installation
1. Refer to the "Make Gas Connection" section for properly
connecting the cooktop to the gas supply.
2. Refer to the "Electronic Ignition System" section for proper
burner ignition, operation, and burner flame adjustments.
IMPORTANT: You may have to adjust the Lo setting for each
cooktop burner.
Checking for proper cooktop burner flame is very important.
The small inner cone should have a very distinct blue flame
/ " (0.64 cm) to / " (1.3 cm) long. The outer cone is not
1 1
4 2
as distinct as the inner cone. LP gas flames have a slightly
yellow tip.
3. Refer to "Complete Installation" in the "Installation
Instructions" section of this manual to complete this
procedure.
17