KitchenAid KGCU407 Instructions D'installation page 13

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

On Griddle Models:
Support the control console in the middle with one arm and
disconnect the griddle switch connectors and the grill
indicator light with the other hand.
A. Griddle switch connectors
B. Grill indicator light connector
7. Remove console and set aside.
8. Remove the round gasket from the valve stem.
9. Put a control knob onto the valve stem of the burner you
want to adjust.
10. Turn the control knob to LO and light the burner using a
butane extension lighter.
11. Remove the control knob.
12. Use a
/
" x 4
/
" flat-blade screwdriver to adjust the flame
1
1
8
4
height. Tighten screw to reduce flame height. Loosen screw
to increase flame height.
NOTE: When you are converting to LP gas, the screw should
be tightened down completely on the single output valves.
The dual output valve should not be adjusted.
A
A. Single flame burner adjustment screw (on right side of valve)
B. Dual flame burner adjustment screw (on left side of valve)
B
A
B
13. When finished adjusting the flame height, put a control knob
back onto the valve stem and turn off the burner.
14. Remove the control knob.
15. Replace the round gasket.
16. Repeat steps 8 through 15 for any other burners that need
adjustment.
17. Reinstall the control console. Support the control console in
the middle with one arm and reconnect the griddle switch
connectors and/or grill indicator light connector.
18. Set the control console back into place on the cooktop. For
a proper fit, the flange of the control console must hook over
the lip on the front of the cooktop.
A
B
A. Control console flange
B. Front lip of range cooktop
19. Check that the control console is flush with the top edge of
the cooktop.
A
A. Flush with top of cooktop
20. Replace the 2 screws on each side of the control console.
21. Push the cooktop back into place in the cutout.
22. Replace the control knobs.
23. Replace burner grates.
24. Plug in cooktop or reconnect power.
25. Test the flame by turning the control from LO to HI, checking
the flame at each setting.
13

Publicité

Table des Matières
loading

Table des Matières