Ec Declaration Of Conformity; Cleaning And Maintenance - Bresser MyTime iO Mode D'emploi

their voltage supply, effective range, and life span.
3. All units required are within range and the path is
clear of obstacles and interference. Shorten the
distance if necessary.
Transmission collision
Signals from other household devices, such
as door bells, home security systems and
entry controls, may interfere with those of this
product and cause temporarily reception failure.
This is normal and does not affect the general
performance of the product. The transmission
and reception of temperature readings will resume
once the interference recedes.
Other malfunctions
If there is no response from the wall clock by
keystrokes or if any other malfunctions occur
perform the following steps.
NOTE!
With this procedure all received data will be deleted.
1. Press RESET button (10) with a pointed
instrument (e.g. pen).
2. The clock hands will move to their start position
(12:00 a.m.) and the wall clock then tries to
receive the signal.
3. Wait approx. 2-5 minutes until the current time
will be displayed.

CLEANING AND MAINTENANCE

Before cleaning the device, disconnect it from the
power supply (remove batteries)!
Only use a dry cloth to clean the exterior of the
device. To avoid damaging the electronics, do not
use any cleaning fluid.
Protect the device from dust and moisture. The
batteries should be removed from the unit if it has
not been used for a long time.
ENTSORGUNG
Dispose of the packaging materials properly,
according to their type, such as paper or
cardboard. Contact your local waste-disposal
service or environmental authority for information
on the proper disposal.
Do not dispose of electronic devices in the
household garbage!
As per Directive 2002/96/EC of the European
Parliament on waste electrical and electronic
equipment and its adaptation into German
law, used electronic devices must be collected
separately and recycled in an environmentally
friendly manner.

EC DECLARATION OF CONFORMITY

Bresser GmbH declares that the device
(MyTime iO Wall Clock / Art.No.: 80-20210)
is in accordance with applicable guidelines and
corresponding standards of the 2014/53/EU
directive. Find the complete declaration under:
www.bresser.de/download/8020211000000/
CE/8020211000000_CE.pdf
DE
GB
FR
IT
ES
9