Instruction Manual - Bresser MyTime iO Mode D'emploi

ABOUT THIS INSTRUCTION MANUAL
These operating instructions are to be
considered a component of the device. Please
read the safety instructions and the operating
instructions carefully before use. Keep these
instructions for renewed use at a later date. When
the device is sold or given to someone else, the
instruction manual must be provided to the new
owner/user of the product.
This product is intended only for private use.
GENERAL WARNINGS
CHOKING HAZARD!
Keep packaging material, like plastic bags and
rubber bands, out of the reach of children, as these
materials pose a choking hazard.
RISK of ELECTRIC SHOCK!
This device contains electronic components that
operate via a power source (batteries). Children
should only use the device under adult supervision.
Only use the device as described in the manual;
otherwise, you run the risk of an electric shock.
RISK of FIRE/EXPLOSION!
Do not expose the device to high temperatures.
Use only the recommended batteries. Do not short-
circuit the device or batteries, or throw them into
a fire. Excessive heat or improper handling could
trigger a short-circuit, a fire or an explosion!
NOTE!
Do not immerse the unit in water.
Do not subject the unit to excessive force, shock,
dust, extreme temperature or high humidity, which
may result in malfunction, shorter electronic life
span, damaged batteries and distorted parts.
Do not disassemble the device. In the event of a
defect, please contact your dealer. The dealer will
contact the Service Centre and can send the device
in to be repaired, if necessary.
Use only the recommended batteries. Always
replace weak or empty batteries with a new,
complete set of batteries at full capacity. Do not
use batteries from different brands or with different
capacities. Remove the batteries from the unit if it
has not been used for a long time.
The manufacturer is not liable for damage related
to improperly installed batteries!
GENERAL INFORMATION
This item is available in the following variants. The
functions and technical data are the same for all
models. They only differ in the colour of the dial
plate.
8020211 B4K000: green
8020211 CM3000: black
8020211 E8G000: red
8020211 GYE000: white
8020211 MGU000: anthracite
8020211 SX9000: sky blue
8020211 URJ000: purple
8020211 WXH000: blue
SCOPE OF DELIVERY
Wall clock (A), Remote sensor (B), Instruction
manual
Required batteries: 3 x 1.5V battery (Size AA/LR6)
and 2 x 1.5V battery (Size AAA/LR03)
Batteries not included with purchase.
PARTS OVERVIEW
Wall clock (Fig. 2)
A. Locking pin
1. Dial plate
2. Clock hands (hours, minutes, seconds)
3. Humidity display (indoor)
4. Temperature display (indoor)
5. Temperature display (outdoor)
6. Wall mount
7. Battery compartment 1 (Clock)
8. Battery compartment 2 (Temp. and humidity
display)
9. M.SET button
10. RESET button
11. REC button
12. °C/°F/DOWN button
13. CH/UP button
Remote sensor (Fig. 3)
14. Function light
15. Wall mount
16. Battery compartment
17. Table stand (fold-out)
GETTING STARTED/POWER SUPPLY
NOTE!
Note the right order before operating the device
for the first time or when replacing the batteries.
Make sure to place the batteries strictly according
(Fig. 1)
DE
GB
FR
IT
ES
7