ETNA KIF577ZT Mode D'emploi page 43

TROUBLESHOOTING
Symptom
Bridge zone link symbols
appears in the displays. The
slider is not working.
Error code E1 or E2.
Error code E3 or E4.
Error code E5 or E6.
Other error codes.
Possible cause
The bridge zone link function
is activated.
Supply voltage or frequency is
different from the rated values.
Internal temperature of the
hob is too high.
Internal temperature of hob is
too high.
Defective generator.
Solution
Deactivate the bridge zone
link function.
Contact a certified installer.
Switch off the hob and let
it cool down (H disappears
from the displays). Switch
on the hob. If the same error
is displayed again, call an
authorised service agent.
Check if hob has enough
ventilation, and is build in
correctly. Let the hob cool
down, and try to restart the
hob. Check whether the fan
runs smoothly; if not, Call a
service technician.
Contact the service
department.
EN 21