Self-Diagnosis - EWT SNOWAIR9H Manuel D'utilisation

• Use a vacuum cleaner to remove any dust that has
accumulated on the filter. If the filter is very dirty, put it
into hot water and rinse it several times. The temperature
of the water should not be higher than 40°C (104°F).
After washing it, leave the filter to dry then attach the
entrance intake grill to the appliance.
THIS APPLIANCE IS SOLELY DESIGNED FOR DOMESTIC USE
www.ewt-france.com
TROUBLESHOOTING

SELF-DIAGNOSIS

The appliance has a self-diagnosis system that allows it
to identify a number of malfunctions. Error messages are
displayed on the screen of the appliance.
IF THE FOLLOWING
SYMBOLS APPEAR
ON YOUR SCREEN
LOW TEMPERATURE
(ice prevention)
PROBE FAILURE
(sensor damaged)
FULL TANK
(water tank full)
FR EN
WHAT TO DO?
The appliance is equipped with
an ice prevention system to
avoid excessive build-up of ice.
This appliance will start up
again automatically
the defrosting process has
finished.
If this message is displayed,
contact your certified repair
centre.
Empty the inner tank following
the instructions above in the
"Operations at end of period of
use" section.
NL
when
29