EWT SNOWAIR9H Manuel D'utilisation page 22

ASSEMBLY
OT AIR EVACUATION TUBE
When set to air-conditioning mode, the appliance must be
placed close to a window or another opening for the hot air
to be evacuated outside.
First, place the unit onto a level area of floor and make sure
that there is a distance of at least 45cm all the way around
the unit as well as a power socket nearby.
Extend the side of
hose
4 Attach the tube exit section to the sliding window kit and
seal it (Fig. 5 and 6).
Lock
Slide in
22
1 Unfold one end of the tube
(Fig. 1) and screw it onto the
tube input section (Fig. 2).
2 Unfold the other end of the
tube and screw it onto the
tube outlet section (Fig. 3).
3 Fit the tube input section
onto the unit (Fig. 4).
Vertical window
Lock in place
Sliding section
Horizontal
window
Sliding section
Your sliding window kit has been designed to be fitted to
most vertical and horizonal sliding windows. However, it may
be necessary to modify some elements of the installation for
certain types of window. The sliding window kit can be fitted
using screws.
NOTE: If the window you are using is shorter/narrower than
the minimum length of the sliding window kit, you can cut it
on the side without the hole so that it fits the window. Never
cut the section that has the hole.
Cut on the side without the
hole
FR EN
www.ewt-france.com
NL