Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
APPLIANCE ON/OFF
Plug the cable of the appliance into the socket to switch on
standby mode.
Press the
button to switch the appliance on. The function
set to start up will be the one in use when the appliance was
last switched off.
Never switch the appliance off by unplugging it from the
power socket. Always press the
minutes before unplugging the appliance. This will allow the
appliance to carry out a series of automatic checks prior to
switching off.
SETTING MODES
AIR-CONDITIONER MODE
Ideal in hot weather when you need to cool a room down.
In order to set this mode correctly:
•
Press the button until you see the
•
Select a temperature value between 18°C and 32°C (64°F
- 90°F) by pressing the
the required value.
•
Select fan speed by pressing the
Three speeds are available:
Maximum speed: maximum power of the fan
Medium speed: reduces the noise level but maintains a
certain level of comfort
Low speed: the appliance will operate silently
AUTO-ECO automatic speed: the appliance will
automatically adapt the ventilation speed according to
the selected temperature for energy efficiency reasons.
When the temperature of the room is 2°C or more above the
selected temperature, ventilation speed will be fast.
When the temperature of the room is 1°C above the selected
temperature, ventilation speed will be medium.
When the temperature of the room is equal to or lower than
the selected temperature, ventilation speed will be slow.
The best temperature for a room in summer is between 24°C
and 27°C (75°F to 81°F). It is, however, recommended that you
don't set a temperature lower than the outside temperature.
24
button then wait a few
symbol appear.
or
buttons until you reach
button.
The difference in fan speed is more noticeable when the
appliance is set to FAN mode but may not be noticeable in
AIR-CONDITIONING mode.
HEATER MODE
In order to correctly switch on heater mode, please follow
these instructions:
•
Press the button until you see the
•
Select a temperature value between 13°C and 27°C (55°F
- 81°F) by pressing the
the required value.
•
Select fan speed by pressing the
Three speeds are available:
Hight heating speed: maximum power of the fan
Medium heating speed: reduces the noise level but
maintains a certain level of comfort
Low heating speed: the appliance will operate silently
AUTO-ECO automatic speed: the appliance will
automatically adapt ventilation speed according to the
selected temperature for energy efficiency reasons.
When the temperature of the room is higher than 25°C,
heating speed will be high.
When the temperature of the room is between 23°C and 25°C,
heating speed will be normal.
When the temperature of the room is below 23°C, heating
speed will be low.
When this mode is activated, the dehumidification function
will also be activated.
In HEATING mode, the drainage pipe (18) needs to be
fitted as for DEHUMDIFICATION mode, to allow water to be
evacuated outside.
NOTE:
-
When the appliance is in a room with a low temperature,
it will automatically activate its frost setting.
-
The appliance will interrupt normal operation of the
ventilator (in Air Conditioner, Heater and Ventilation
mode).
FR
EN
symbol appear.
or
buttons until you reach
button.
www.ewt-france.com
NL
Publicité
Table des Matières
