Cleaning The Blender; Storage; Troubleshooting - Bosch MUM59 Série Mode D'emploi

en

Storage

Cleaning the bowl and tools
The bowl and tools are dishwasher­
proof. Do not wedge plastic parts in the
dishwasher, as they could be permanently
deformed during the washing process!
Cleaning the continuous-feed
shredder
W Risk of injury from sharp blades!
Do not grip the sharp blades or edges of the
cutting discs. Clean them with a brush.
All parts of the continuous­feed shredder
are dishwasher­proof.
Tip: To remove the red film after processing
e.g. carrots, pour a little cooking oil on a
cloth and rub the film off the continuous­
feed shredder (not the cutting discs). Then
rinse the continuous­feed shredder.

Cleaning the blender

W Risk of injury from sharp blades!
Do not touch blender blades with bare
hands.
The blender jug, lid and funnel are
dishwasher­proof.
Tip: After processing liquids, it is often
sufficient to clean the blender without
removing it from the appliance. Pour a little
water and washing­up liquid into the attached
blender. Switch on the blender for several
seconds (setting M). Pour out the water and
rinse out the blender with clear water.
Important information
If required, clean accessories bag. Follow
care instructions in the bag.
Storage
W Risk of injury!
When the appliance is not in use, pull out
the mains plug.
Figure L:
■ Store tools and cutting discs in the
accessories bag.
■ Keep accessories bag in the bowl.
24

Troubleshooting

W Risk of injury!
Before eliminating a fault, pull out the mains
plug.
Note:
The Operating indicator flashes if the
appliance has been operated incorrectly
or the electronic fuse has tripped or the
appliance is defective.
The swivel arm must be engaged in
every operating position.
Initially try to eliminate the problem which
has occurred with the help of the following
information.
Troubleshooting
Appliance does not start.
Remedial action
■ Check the power supply.
■ Check the mains plug.
■ Check swivel arm. Correct position?
Engaged?
■ Screw on blender or bowl as far as
possible.
■ Attach the blender cover and screw on
as far as possible.
■ Attach drive cover to unused drives.
■ The safety lock is active. Switch
appliance to 0/off and then back to the
required setting.
Troubleshooting
Appliance switches off during use. The
overload protection feature has been
activated. Too much food was processed
at one time.
Remedial action
■ Switch off the appliance.
■ Reduce processing quantity. Do not
exceed permitted maximum quantities
(see "Application examples").
Troubleshooting
While the drive was running, the release
button was inadvertently pressed. The
swivel arm moves up. The drive switches
off, but does not stop in the tool change
position.