DeWalt D55151 Guide D'utilisation page 22

CODE POSSIBLE CAUSE
17 Carbon build-up in pump.
18 Detergent type oil being used in pump
19 Motor overload protection switch has tripped
20 Extension cord is wrong length or gauge
21 Loose electrical connections
22 Possible defective motor or starting capacitor
23 Paint spray on internal motor parts
24 Fuse blown, circuit breaker tripped
25 Tank pressure exceeds pressure switch cut-in pressure
26 Pressure release valve on pressure switch has not unloaded
head pressure
POSSIBLE SOLUTION
Contact a D WALT factory service center or a D
e
authorized service center.
Drain oil and refill pump using DeWALT synthetic or SAE 40,
non-detergent air compressor oil.
See Motor Overload under Features.
Check for proper gauge wire and cord length. See Extension
Cords under Installation.
Contact a D WALT factory service center or a D
e
authorized service center.
Contact a D WALT factory service center or a D
e
authorized service center.
Contact a D WALT factory service center or a D
e
rized service center. Do not operate the compressor in the
paint spray area. See flammable vapor warning.
1. Check fuse box for blown fuse and replace as necessary.
Reset circuit breaker. Do not use a fuse or circuit breaker
with higher rating than that specified for your particular
branch circuit.
2. Check for proper fuse. Use only a time delay fuse.
3. Check for low voltage conditions and/or proper extension cord.
4. Disconnect the other electrical appliances from circuit or
operate the compressor on its own branch circuit.
Motor will start automatically when tank pressure drops
below cut-in pressure of pressure switch.
Set the On/Off switch to OFF. If the valve does not open,
replace switch. Contact a D
D WALT authorized service center.
e
22
WALT
e
WALT
e
WALT
e
WALT autho-
e
WALT factory service center or a
e