Adjusting The Boundary Range: Warning Area And Stimulation Area - Num'axes Canifugue Mix FUG1033 Guide D'utilisation

Masquer les pouces Voir aussi pour Canifugue Mix FUG1033:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 3
Fitting the battery in the receiver collar
− Unscrew the 4 screws of the battery cover using a screwdriver.
− Insert the battery (3V Lithium CR2) paying attention to follow polarity
indicated on the battery housing.
− A beep sound is emitted indicating the correct installation of the battery. If
you do not hear any beep sound after having inserted the battery, remove it
immediately from its housing. Check the polarity before trying again.
− Before putting the lid back in place, check that the rubber seal is in its groove.
− Retighten moderately the 4 screws.
Activate/deactivate the receiver collar
The supplied magnetic key allows you to activate/deactivate the collar.
• Activate: move the magnetic key towards the collar so that it comes into contact with the
hold for 1 second (ref. Diagram 6). The collar will emit one beep sound and the indicator light will flash in green indicating
the collar is On.
• Deactivate: move the magnetic key towards the collar so that it comes into contact with the
collar, hold for 1 second (ref. Diagram 6). The collar will emit two beep sounds and the indicator light will flash in red then
go out indicating the collar is Off.
To increase the battery life, we recommend you to deactivate the collar if you are not using it for a long period.
If your dog needs to leave the authorized area, you have to remove the collar or deactivate the transmitter by disconnecting
it from the power supply.
Diagram 6
Activate/deactivate
the receiver collar
with the magnetic key

Adjusting the boundary range: warning area and stimulation area

Adjustment buttons on the transmitter enable you to increase or decrease the width of the warning and stimulation zones
depending on the configuration of your yard and how the wire is laid.
First of all, select on the transmitter the position of the small/large ground selector according to your ground:
guide canifugue MIX FUG1033 IndB.indd 27
Magnetic key
(magnet)
27
Battery polarity
indicators
Diagram 5
Battery
Seal
symbol located on the collar,
symbol located on the
02/04/2019 11:01

Publicité

Table des Matières
loading

Table des Matières