Miele PW 5105 Mode D'emploi page 31

Produktgruppen 512, 592
31 von 34
am
Parts required
Quantity Mat. no.
1 09038900
1 09038870
Note
This service and repair work should only be carried out by a suitably qualified electrician (with specialist
training, knowledge and experience, and recent related work experience) in accordance with all appropriate
local and national safety regulations.
Servicing, modification, testing and maintenance of electrical appliances should only be carried out in
accordance with all appropriate legal requirements, accident prevention regulations and valid standards. All
regulations of the appropriate utility supply companies and standards relating to safety (not limited to electrical
safety) are to be complied with.
Danger!
Even with the machine switched off, voltage may be applied to some components.
Before starting any service work, the machine must be disconnected from the power supply. Suitable
measurements must be made to ensure that this is the case.
A general visual check should always be carried out.
Incorrect conversion or service work could lead to a risk of fire or gas explosion.
Danger!
Risk of injury during installation:
Risk of electric shock. Before starting any service work, the machine must be disconnected from the
power supply.
Installation can only be carried out with the washing machine or tumble dryer not installed. For
deinstallation, see the appropriate operating instructions.
Risk of crushing. Wear slip-proof working gloves and safety shoes.
Risk of crushing. When carrying out work, ensure that parts of the body, especially the hands and feet,
are not positioned under or between machines.
Risk of accident. Ensure that children or pets cannot access the work area while installation work is
being carried out.
Risk of injury, particularly to the back. The relation of the weight of the machine to the physical strength
of the technician must be taken into account. For machine weight details, see the operating instructions.
Risk of injury due to incorrect installation:
Always bolt the machine to the stand.
For a single installation, bolt the stand to the floor using the supplied foundation kit, mat. no. 01497252.
With floor mounting, secure all four brackets.
The stand is not to be used for washer-dryer stacks.
Note
Use this stand only for the following Miele machines:
PW 5105
06.01.2011 Diese Unterlagen dürfen ohne unsere Genehmigung weder vervielfältigt noch Dritten zugänglich gemacht werden. Eigentumsrechte vorbehalten.
Umbau- und Montageanweisung
Designation
Stand kit UO 5010
Stand kit UG 5010
M.-Nr. 09059270