SOMFY Dexxo Pro io Manuel D'utilisation page 24

Dexxo Pro io
General stop
General closure
interrupted motion
Movement not performed
> using Keygo or similar remote controls
open
Close
stop
4
> obstacle detection operation
The detection of an obstacle during door opening will stop the door and cause it to
reopen slightly to clear the obstacle
When an obstacle is detected during the close cycle, the door will stop and
then reopen
Once an obstacle has been detected, the light will flash for 30 seconds.
> light operation
The light will come on each time the motor drive unit is operated. The light will
go out one minute after the door stops moving.
Repetitive use that causes the light to be continually on may result in a thermal
cut out.
> Manual release cord operation
Dexxo Pro is fitted with a manual release mechanism so that you can move the
door manually should a power failure occur, for example. The manual release
mechanism should be easily accessible and located no more than 1.80 metres
above floor level.
[1]. Disengaging the motor drive mechanism
Pull on the manual release cord until the door drive mechanism is
disengaged.
[2]. Manually moving the door
This is possible as long as the door drive mechanism is disengaged.
[3]. Reengaging the motor drive mechanism
Move the door manually until the drive mechanism comes to reengage
itself into the transmission rail.
When disengaging the motor drive mechanism, use caution for a
badly balanced door may cause sudden door movement
that may be dangerous.
Only use the cord to disengage the motor drive mechanism. Never
use the cord to move the door manually.
Copyright © 2015 Somfy SAS. All rights reserved