Spypoint LIVE-3G Manuel D'utilisation page 8

14
When selected, some options affect the behaviour of other
options from the list of the settings menu. In this case, the
selected option is displayed in yellow and options affected are
shown in gray.
Set the date as Year/Month/Day
Date:
Set the time as Hour/Minute/Second
Time:
Note: The seconds are not printed on the pictures
when «Stamp» option is activated.
Allows the user to choose between a 12 or
Time format:
(12h/24h)
24 hours period time displays on the photos.
(eg. 6:00 pm or 18:00)
Date and Time are synchronized with the
Auto time:
(Yes/No)
cellular network when available.
Sets the time interval to wait between each
Delay:
(10s/1min/3min/
detection before the camera records the next
5min/10min/
photo or video.
15min/30min)
Additional setting: It is possible to decrease the
delay between detections to 10 seconds (instead
of 1 minute) by using the following procedure.
Note that the battery life will be affected.
Turn OFF the camera. Press and hold the
▲
button and turn the camera ON . «10sec
enabled» appears on the screen meaning the
minimum delay is now 10 seconds. To reset
the camera to 1 minute delay, follow the same
procedure. «10sec disabled» appears on the
screen (see figure below)
10s enabled
Sets the recording time of video in VIDEO
Video length:
(10s/30s/60s/90s)
mode.
10s disabled
10 sec delay 1 min delay
Allows the camera to take several consecutive
Multi-shot:
(1/2/3/4/5/6
shots at each detection with a 10 second delay
consecutive shots)
between each photo.
Allows the camera to take pictures at regular
Time Lapse:
(Off/10min/
preset intervals. This option may be useful to get
30min/1h/2h)
pictures of animals outside the detection range
of the camera.
When the option «Time Lapse» is enabled:
• The «Delay» option is disabled.
• The «Multi-shot» option is disabled.
• The picture size is reduced to 800x600 in local
recording on the memory card.
Note: The «Time Lapse» recording option only
applies in PHOTO mode, not in VIDEO mode.
Allows the user to set the period of operation of
Work:
the camera for each day of the week. The start
and stop time are the hours during which the
camera is in action and can record pictures or
videos.
Example: If the user selects a start time «15h»
and a stop time «19h», the camera will only
detect for that period of time and will stay
inactive for the remaining hours. Press OK and
▲ ▼
use or to adjust the hour. When the time is
properly set, press OK again to go back to other
settings. For an activation of 24 hours, the same
start and stop time must be entered (example:
00h as start time and 00h as stop time. These
hours are the default configuration of your
camera).
To turn off the camera, enter «--h» as start time
or end time. The camera is inactive for that day.
Note: The hours can be recorded over a 12 or 24
hours period. Refer to the «Time format» option
(00h means midnight)
15