Eschenbach Powerlux Mode D'emploi page 7

The device components
q Lens
w Lighting switch
e Battery compartment
r Battery compartment cover
Setting Up
1. Remove the device from the packaging.
2. Open the battery compartment e on the rear panel of the
device. For this press on the area with the two small bars and
slide the battery compartment cover r away from the device.
3. According to the positioning diagram in the battery
compartment e place 3 x 1.5 V Batteries, Type Mignon, size
AA, into the compartment e.
4. Close the battery compartment e.
Using powerlux
1. move powerlux with the lens q over the text that is to be
magnified.
2. Powerlux has two SMD high performance LEDs for even
illuminating of the reading area. To switch on the built-in LED
lighting please press the button w.
After approx. 30 minutes the lighting switches off
automatically. If, after this time, you want to continue using the
lighting press the button w again to switch the lighting back
on.
3. After approx. 30 minutes the lighting switches off automatically.
As a result of this, unnecessary depletion of the batteries will
be avoided if you forget to switch powerlux off after use.
If you use powerlux for less than 30 minutes you can switch
the lighting off by pressing the button w.
7