Publicité
q
w
e
r
y
t
000357
602053
EMU00976
Removing the Propeller
1) Straighten the cotter-pin 1 and pull it
out using a pair of pliers.
2) Remove the propeller nut 2, washer
3 and spacer 4
3) Remove the propeller 5 and thrust
washer 6.
EMU01442
Installing the Propeller
w
On counter-rotation models, be sure to
use a propeller intended for counterclock-
wise rotation. These propellers are identi-
fied with the letter "L" after the size indi-
cation on the propeller. Otherwise, the
boat may move in the opposite direction
from that expected.
cC
8 Be sure to install the thrust washer
before installing the propeller, other-
wise the lower case and propeller boss
may be damaged.
8 Be sure to use a new cotter pin and
bend the ends over securely. Other-
wise, the propeller could come off dur-
ing operation and be lost.
1) Apply Yamaha Marine grease or a
corrosion resistant grease to the pro-
peller-shaft.
2) Install the thrust washer and propeller
on the propeller-shaft.
3) Install the spacer and washer. Tighten
the propeller nut to the specified
torque.
Tightening torque:
Refer to "SPECIFICATIONS",
page 4-1.
4-19
GB
Publicité
Chapitres
