Saving Images - Canon EOS REBEL T6 (W) Mode D'emploi De Base

Saving Images

This section explains how to connect the camera and Connect Station
(sold separately) wirelessly. To save images in other ways, refer to the
Connect Station Instruction Manual.
Set up the camera to allow use of its NFC function in advance

(p.W-14).
NFC connect point
W-36
Enable the NFC function on the
1
camera
(p.W-14)
Hold the camera close to Connect
2
Station.
Turn on the camera and Connect

Station, then hold the camera's p
mark close to the Connect Station's
NFC connect point.

When a message indicating the
connection is displayed on the
camera's LCD monitor and Connect
Station responds, move the camera
away from Connect Station.
When a connection is established,

Connect Station checks the images
on the memory card, then saves only
the unsaved images.
 The camera's <k> lamp will light up
in green.
Terminate the connection.
3
After images are saved, the screen

on the left will appear on the camera's
LCD monitor. Press <0> to
terminate the connection.
.