Smeg BCC01 Manuel De L'utilisateur page 15

USE (Fig. E-F-G-H)
• Lift the lid (4) and insert cold water into the
tank (5) taking care not to exceed the 'Max'
level indicated, then refit the lid (4).
• Lift the lid (2) and insert coffee beans into
the container (3).
• Check that the drip tray (14) is correctly
positioned.
• Press the button (9)
the heating phase and the keys light up
flashing in sequence.
At the end of the heating, a self-cleaning
cycle of the internal circuits is carried out
and, once the cycle is finished, the machine
is ready to be used.
At the first use it is recommended to
make at least one coffee to make a
complete break-in of all the circuits.
After 20 minutes of non-use, the
machine switches off. If it has made
at least one coffee, it performs a
self-cleaning cycle. Press the button
(9) to switch on the machine.
Change of dispensing program
The machine has two dispensing menus in
its memory: Primary and Secondary. To
switch from one program to another, press the
key(20) .
In the Primary menu all the keys are illuminated
in white, in the Secondary menu, all the keys
are illuminated in orange.
For the specific functions of each menu, refer
to the paragraph "DESCRIPTION OF
CONTROLS AND ALARMS"
Turning off the machine the setting
of the Primary or Secondary
dispensing menu remains in the
memory at the next restart.
EN - 10
Use
, the machine starts
Dispensing a drink
• It is possible to adjust the position of the
dispenser (11) according to the cup used.
For very high cups it is possible to remove
the drip tray (14).
• Place a cup or large cup under the
dispenser.
• Press the key for the desired function. For
each selected function, preparation stops
automatically. For specific functions, refer
to the paragraph "DESCRIPTION OF
CONTROLS AND ALARMS".
• At the end of dispensing, all the keys light
up fixed.
Dispensing can be stopped at any
time by pressing the dispensing
key again.
Remember to reassemble the tray
(14) at the end of any dispensing.
It is completely normal that after a
prolonged inactivity of the machine
(breaks longer than 20 min) the
first coffees are not at the right
temperature. The tips to obtain a hot
coffee immediately are given in the
section "What to do if..."
Customization of the quantity
It is possible to customize, for each type of dispensing,
the quantity of coffee or water dispensed.
• Place a cup or large cup under the
dispenser.
• Press for at least 3 seconds one of the
keys relative to the drink to be dispensed.
The selected key lights up flashing; the
machine emits a double sound to signal
the modification of the preset program.
• On reaching the desired quantity, stop
dispensing by pressing the key again; an
acoustic signal indicates the memorization
of the quantity.