Use Of Dishwasher Salt - ZANKER KDI 10000 Notice D'utilisation

Manual adjustment
1
Electronic adjustment
1. Press and hold the start/cancel button.

Use of dishwasher salt

1
3
Fill the salt container with
1 litre of water (only for
the first time you fill with
salt).
2
Turn the water hardness
dial to the position 1 or 2
(refer to the table).
2
4
2. Turn the programme knob clockwise until the pro-
gramme marker is aligned with the first washing
programme.
3. Release the start/cancel button when the on/off in-
dicator and the start/cancel indicator start to flash.
• At the same time, the end indicator flashes inter-
mittently. The number of flashes shows the set-
ting of the water softener (example: 5 flashes /
pause / 5 flashes = level 5).
4. Press the start/cancel button again and again to
change the setting. Each time you press the start/
cancel button, the adjustment increases by 1 level.
5. Deactivate the appliance to confirm.
If the water softener is set electronically to the lev-
el 1, the salt indicator light stays off.
5
It is correct that water comes out from the salt
container when you fill it with salt.
6
21