Preparing The Stove - Dovre 750 GH Mode D'emploi Et Installation

3.2.

Preparing the stove

Please inspect the stove for damage caused during transport immediately after deliv-
ery and notify your distributor in case there are any defects. Do not put the stove
into operation in the meantime.
In order to avoid damaging the stove during installation and to make handling of the
stove easier, it is recommended to remove previously all loose parts (fire-resistant
bricks, ashtray, ...) from the stove. Note the location of those parts while removing
them, so that you have no difficulties in re-assembling the parts later on.
3.2.1. Smoke outlet
Your stove is suitable for two connections: a top or a rear connection.
Upon supply, the top and rear exhausts have been left open. Depending on the posi-
tion chosen, one opening can be covered with the blanking plate supplied; the other
one can be equipped with the connection collar supplied (see picture). Use the fix-
ings supplied and be sure to tightly seal the connection collar and the blanking plate
to the stove by means of the kit or paste supplied.
25
750GH - 750GM 03.27885.100