Bosch GCM 10 GDJ Professional Notice Originale page 35

(38) Linkage of the retracting blade guard
(39) Front fastening screw
(cover plate/retracting blade guard)
(40) Rear fastening screw
(cover plate/retracting blade guard)
(41) Cover plate
(42) Spindle lock
(43) Hex socket screw for mounting the saw blade
(44) Clamping flange
(45) Inner clamping flange
(46) Locking screw for the adjustable fence
(47) Damper
(48) Set screws for damping
(49) Holes for screw clamp
(50) Threaded rod
Technical Data
Sliding mitre saw
Article number
Rated power input
No-load speed
Starting current limitation
Weight according to EPTA-Procedure 01:2014
Protection class
Dimensions of suitable saw blades
Saw blade diameter
Base blade thickness
Max. cutting width
Hole diameter
The specifications apply to a rated voltage [U] of 230 V. These specifications may vary at different voltages and in country-specific models.
Permitted workpiece dimensions (maximum/minimum): (see "Permissible workpiece dimensions", page 40)
Noise Information
Noise emission values determined according to EN
62841-3-9.
Typically, the A-weighted noise level of the power tool is:
Sound pressure level 93 dB(A); sound power level
106 dB(A). Uncertainty K = 3 dB.
Wear hearing protection!
The noise emission value given in these instructions has
been measured in accordance with a standardised measur-
ing procedure and may be used to compare power tools. It
may also be used for a preliminary estimation of noise emis-
sions.
The noise emission value given represents the main applica-
tions of the power tool. However, if the power tool is used
for other applications, with different application tools or is
Bosch Power Tools
(51) Angle indicator for mitre angles
(52) On/off switch
(53) Screws for insert plate
(54)/ Set screws for 0° basic setting (bevel angle)
(55)/
(56)
(57) Set screw for 45° basic setting (left-hand bevel
angle)
(58) Set screw for 45° basic setting (right-hand bevel
angle)
(59) Set screws for mitre angle scale
(60) Screw for mitre angle indicator
(61) Set screw for adjusting the clamping force of the
clamping handle for any bevel angle
(62) Hook-and-loop strap
GCM 10 GDJ
3 601 M27 04.
3 601 M27 0L.
3 601 M27 08.
3 601 M27 0B.
3 601 M27 0K.
W
-1
min
kg
mm
mm 1.7–2.6
mm
mm
poorly maintained, the noise emission value may differ. This
may significantly increase noise emissions over the total
working period.
To estimate noise emissions accurately, the times when the
tool is switched off, or when it is running but not actually be-
ing used, should also be taken into account. This may signi-
ficantly reduce noise emissions over the total working
period.
Assembly
Avoid starting the power tool unintentionally. The
u
mains plug must not be connected to the power supply
during assembly or when carrying out any kind of
work on the power tool.
English | 35
GCM 10 GDJ
3 601 M27 00.
3 601 M27 03.
3 601 M27 06.
3 601 M27 07.
2000
5000
●
31.6
/ II
254
1.7–2.6
3.2
25.4
1 609 92A 5U5 | (01.10.2020)
2000
5000
●
31.6
/ II
254
3.2
30