Storage; Disposal - RedMax BCZ230S Mode D'emploi

BCZ230S/BCZ230TS
9. Maintenance
■ BEVEL GEAR (MA6)
MA6
• The bevel gear is filled with the right
quantity of grease at the factory.
However, before using the machine
you should check that the bevel gear is
filled three-quarters full with grease.
Use lithium-based grease.
• The grease in the bevel gear does not
normally need to be changed except if
repairs are carried out.
■ INTAKE AIR COOLING VENT
• Never touch the cylinder, muffler, or
spark plugs with your bare hands
immediately after stopping the
engine. The engine can become
very hot when in operation, and
doing so could result in severe
burns.
• When checking the machine to make
sure that it is okay before using it,
check the area around the muffler
and remove any wood chips or
leaves which have attached
themselves to the grass trimmer.
Failing to do so could cause the
muffler to become overheated, and
that this in turn could cause the
engine to catch on fire. Always
make sure that the muffler is clean
and free of wood chips, leaves, and
other waste before use.
• Check the intake air cooling vent and
the area around the cylinder cooling
fins after every 25 hours of use for
blockage, and remove any waste which

10. Storage

• Aged fuel is one of major causes of
engine starting failure. Before storing
the unit, empty the fuel tank and run
the engine until it uses all the fuel left in
the fuel line and the carburetor. Store
the unit indoor taking necessary
measures for rust prevention.

11. Disposal

• When disposing your machine, fuel or
oil for the machine, be sure to allow
your local regulations.
US-16
WARNING
has attached itself to the grass trimmer.
Note that it is necessary to remove the
engine cover shown in (MA7) in order
to be able to view the upper part of the
cylinder.
MA7
(1)
• If waste gets stuck and causes
blockage around the intake air cooling
(2)
vent or between the cylinder fins, it may
cause the engine to overheat, and that
in turn may cause mechanical failure
on the part of the grass trimmer. (MA7)
(1) cylinder
(2) intake air cooling vent (back)
■ PROCEDURES TO BE PERFORMED
AFTER EVERY 100 HOURS OF USE
MA8 1. Remove the muffler, insert a
screwdriver into the vent, and wipe
away any carbon buildup. Wipe away
any carbon buildup on the muffler
exhaust vent and cylinder exhaust port
at the same time.
2. Tighten all screws, bolts, and fittings.
3. Check to see if any oil or grease has
worked its way in between the clutch
lining and drum, and if it has wipe it
away using oil-free, lead-free gasoline.
IMPORTANT