RedMax BCZ230S Mode D'emploi page 8

BCZ230S/BCZ230TS
5. For safe operation
9. Start the engine only in well ventilated
areas. Never start or run the engine inside
a closed room or building and potentially
explosive atmosphere. Exhaust fumes
contain dangerous carbon monoxide.
10. Never to touch the spark plug or plug cord
while the engine is in operation Doing so
may result in being subjected to an
electrical shock.
11.Never to touch the muffler, spark plug,
other metallic parts of the engine or
engine cover while the engine is in
operation or immediately after shutting
down the engine. These metallic parts
and engine cover reach high
temperatures during operation and doing
so could result in serious burns.
12.To reduce the risk of injury associated
with contacting rotating parts, stop the
engine before installing or removing
attachments. Always disconnect the spark
plug before performing maintenance or
accessing movable parts.
■ BEFORE USE
1. Each time before starting the engine,
inspect the entire unit to see if every part
is in good order and is securely tightened
in place. If any damage is found in the fuel
line, the exhaust line, or the ignition wiring,
do not use the product until it has been
repaired.
WARNING
2. Before starting operation, always make
sure that the cutting attachment and the
cutting attachment guard are properly
installed and securely fastened.
3. Check the condition of working area to
avoid any accident by hitting hidden
obstacles such as stumps, stones, cans, or
broken grass.
IMPORTANT
Remove any obstacle before beginning work.
■ STARTING THE ENGINE
1. Keep bystanders and animals at least 50
feet (15 meters) away from the operating
point. If you are approached, immediately
stop the engine.
2. The product is equipped with centrifugal
clutch mechanism, so the cutting
attachment could rotate as soon as the
engine is started. When starting the
engine, place the product onto the ground
in a flat clear area and hold it firmly in
US-6
place so as to ensure that neither the
cutting part nor the throttle come into
contact with any obstacle when the engine
starts.
3. After starting the engine, check to make
sure that the cutting attachment stops
rotating when the throttle is moved fully
back to its original position (idle position). If
it continues to rotate even after the throttle
has been moved fully back, turn off the
engine and take the unit to your authorized
RedMax servicing dealer for repair.
■ GENERAL WORKING INSTRUCTIONS
IMPORTANT
This section takes up the basic safety
precautions for working with a trimmer.
If you encounter a situation where you are
uncertain how to proceed you should ask an
expert. Contact your dealer or your service
workshop.
Avoid all usage which you consider to be
beyond your capability.
You must understand the difference between
forestry clearing, grass clearing and grass
trimming before use.
BASIC SAFETY RULES
1. Look around you:
• To ensure that people, animals or other
things cannot affect your control of the
machine.
• To ensure that people, animals, etc., do
not come into contact with the cutting
attachment or loose objects that are
thrown out by the cutting attachment.
• CAUTION! Do not use the machine unless
you are able to call for help in the event of
an accident.
2. Inspect the working area. Remove all loose
objects, such as stones, broken glass,
nails, steel wire, string, etc. that could be
thrown out or become wrapped around the
cutting attachment.
3. Do not use the machine in bad weather,
such as dense fog, heavy rain, strong
wind, intense cold, etc. Working in bad
weather is tiring and often brings added
risks, such as icy ground, unpredictable
felling direction, etc.
4. Make sure you can move and stand safely.
Check the area around you for possible
obstacles (roots, rocks, branches, ditches,
etc.) in case you have to move suddenly.
Take great care when working on sloping
ground.