MZ electronic EV-020 Instructions D'utilisation page 31

•
Apply the drill template (see appended instructions) and drill on the
dashboard one hole of 20.5 mm (~13/16") and 4 holes of 2.2 mm (~3/32")
to fasten the connector tap.
•
Put the gasket
between the rear part
of tap and the
dashboard.
•
The rear part must be
protected from
contact with water or
moisture.
•
For instructions on
making electrical
connections, see the
attached diagram.
The wires must have
a minimum cross
section size of 1.5
mm².
•
Install a 3 A (ampere)
fast safety fuse on the + wire of the battery. Do not use the voltage
generated by the engine battery set to provide power.
•
The instrument complies with EMC standards (EN55022) and must be
positioned at a distance of:
− 30 cm (~1 Ft) from the compass;
− 50 cm (~1.5 Ft) from radio equipment;
− 2 metres (~6.5 Ft) from radio transmitter equipment;
− 2 metres (~6.5 Ft) from the radar beam.
EV-020 31
English
Rev. 04 – 2007