Technics SU-G30 Manuel D'utilisation page 44

Troubleshooting
Please Wait
• This is displayed, for example, when this unit
is turned to standby/on. (For up to approx.
1 minute and 30 seconds)
"Remote " (" " stands for a number.)
• The remote control and this unit are using
different codes.
Change the code on the remote control. ( 15)
Remote Mode
• Basic playback control buttons on the remote
control are not available. (While playing back
music stored on the DLNA server with this unit
(DMR), etc.)
• Use the connected device for basic playback
control.
Searching
• The unit is checking the DLNA server on the
network.
Signal Overflow
• The audio from the analog audio input terminal
in use is distorted. Select "Attenuator(LINE)",
and change the setting for the analog audio
input terminal in use to "On". ( 34)
Unlocked
• "PC", "COAX1", "COAX2" or "OPT" is selected,
but no device is connected. Check the
connection with the device. ( 32, 33)
• Audio signals, such as sampling frequency
components, are not input correctly.
- About supported format, refer to "File
format" ( 49)
USB Over Current Error
• The iPhone/iPad/iPod or USB device is drawing
too much power. Disconnect the iPhone/iPad/
iPod or USB device and turn the unit to standby
and on again.
Wi-Fi Setup
• Select "On" and press [OK] to enter the
network setting. ( 19)
- To exit the network setting, select "Off" and
press [OK].
44
(44)
Hub Device Not Supported/Not Supported/
Device Not Recognized/
USB Device Not Supported
• You have connected an iPhone/iPad/iPod or
USB device that is not supported.
- If the iPhone/iPad/iPod is compatible, turn it
on and connect it correctly.
• The format of the file on the iPhone/iPad/iPod
or USB device is not supported.
- About supported format, refer to "File
format" ( 49)