Technics SU-G30 Manuel D'utilisation page 16

Connections
Speakers/AC power supply cord
• Use only the supplied AC power supply cord.
• Do not connect the AC power supply cord until all other connections are complete.
• Insert the plugs of the cables to be connected all the way in.
• Do not bend cables at sharp angles.
• To optimize the audio output, you can measure the amplifier output signal and correct its
output when it is connected to the speakers. ( 39)
Speaker connection
1 Turn the knobs to loosen them, and
insert the core wires into the holes.
2 Tighten the knobs.
16
(16)
PHONO PHONO LINE IN LINE IN
PHONO PHONO
EARTH EARTH
Speaker cable (not supplied)
Note
• When the connections are completed, pull the
speaker cables lightly to check that they are
connected firmly.
• Be careful not to cross (short-circuit) or reverse
the polarity of the speaker wires as doing so
may damage the amplifier.
DO NOT
• Wire the polarity (+/-) of the terminals correctly.
Not doing so may adversely affect stereo
effects or cause malfunction.
• For details, refer to the operating instructions of
the speakers.
LAN LAN
OPT OPT COAX1 COAX1 COAX2 COAX2 PC PC
10BASE-T / 10BASE-T /
DIGITAL IN DIGITAL IN 100BASE-TX 100BASE-TX
SPEA SPEA
(4〜1 (4〜1