Technics SU-G30 Manuel D'utilisation page 43

Remote control
The remote control does not work properly.
• The batteries are depleted or inserted
incorrectly. ( 14)
• To avoid interference, please do not put any
objects in front of signal sensor. ( 12)
• Change the remote control code if other
products react to this remote control. ( 15)
Messages
• The selected file cannot be played back.
• Select the playable file.
- About supported format, refer to "File
format" ( 49)
AUTO OFF
• The unit has been left unused for about 20
minutes and will shut down within a minute.
Press any button to cancel it.
Checking Device
• The unit is checking the connected iPhone/
iPad/iPod or a USB device. After this display has
disappeared, start operating.
Download Fail
• The firmware download has failed. Press any
button to exit. Please try again later.
• The server cannot be found. Press any button to
exit. Make sure that the network is connected
to the internet.
Empty
• The selected folder is empty. Move tracks into
the folder and retry the operation.
• The server is not found on the network. Check
to see if the server is connected to the same
network as this unit, and retry the connection
to this unit. ( 18)
Error
• Incorrect operation is performed. Read the
instructions and try again.
Fail
• Network connection is not complete. Try the
setting again. ( 18)
Firmware update is available
• The firmware (free of charge) for this unit is
available.
Press [OK].
Press [ ], [ ] to select "Yes" and then press
[OK].
• The progress is displayed as "Updating
while updating. ( stands for a number.)
• Do not disconnect the AC power supply
cord or turn this unit to standby while
updating. ( 38)
• When the update has finished successfully,
"Success" is displayed.
Disconnect the AC power supply cord and
reconnect it after 3 minutes.
"F " (" " stands for a number.)
• There is a problem with this unit.
- Is the volume extremely high?
If so, lower the volume.
- Is this unit placed in an extremely hot place?
If so, move this unit to a cooler place and wait
a few moments and then try to turn it on
again.
If the problem persists, write down the
displayed number, disconnect the AC power
supply cord and consult your dealer.
Load Fail
• The firmware on the USB flash memory cannot
be found.
• Download the latest firmware on the USB flash
memory and try again. ( 38)
No Device
• No USB device is connected.
• Connect the USB device to be played. ( 28)
No Network Available
• This unit is not connected to the network.
• Check the network connection. ( 18)
Not Measured
• Measuring the output signal has not been done
yet.
• Measure the output signal. ( 39)
Not Valid
• The function you have tried to use is not
available with the current settings. Check the
steps and settings.
%"
43
Troubleshooting (43)