Technics SU-G30 Manuel D'utilisation page 20

Connections
Network settings
Using the WAC (Wireless Accessory
Configuration)
"WAC Mode for iOS"
You can send its Wi-Fi configuration to this
system using an iPhone/iPad/iPod touch.
• Supported device:
iPhone/iPad/iPod touch (iOS version 7.0 or
later), or Mac (OS X 10.9 or later, with AirPort
Utility 6.3.1. or later)
• The following explanations are based on an
iPhone.
• Make sure your iPhone is connected to your
home wireless network beforehand.
1 Press [ ], [ ] on the remote control to
select "WAC Mode for iOS" and then
press [OK].
• "Setting" is displayed.
2 Go to Wi-Fi settings on your iPhone.
3 Select "Technics SU-G30 ****** "
under the "SET UP NEW AIRPLAY
SPEAKER..." on your iPhone.
• "
" stands for a character that is unique
******
to each set.
4 The "AirPlay Setup" screen appears on
your iPhone.
• This system will be displayed as "Technics
SU-G30 ". To change the name, enter
******
a new name to replace the existing one. You
can also do the renaming after the network
connection is set up. ( 23)
• You can set a password for this system under
"SPEAKER PASSWORD". (You will need this
password if you make network settings by
internet browser next time.)
5 Select "Next" to apply the settings.
• "Linking" is displayed.
• When the connection is established,
"Success" is displayed.
- "Fail" may be displayed if the connection
was not complete. Try this method
again from [SETUP] menu. If "Fail" is still
displayed, try other methods ( 19).
6 Press [OK] on the remote control to
exit the setting.
• " " is displayed.
20
(20)
(Continued)
Using the WPS button
"WPS Push"
If your wireless router supports WPS, you can set
up a connection by pressing the WPS button.
• A compatible wireless router may have the WPS
identifier mark.
1 Press [ ], [ ] on the remote control
to select "WPS Push" and then press
[OK].
• "WPS" is displayed. Complete step 2 within 2
minutes.
2 After "WPS" is displayed, press the
WPS button on the wireless router.
Example:
• "Linking" is displayed.
• When the connection is established,
"Success" is displayed.
- "Fail" may be displayed if the connection
was not complete. Try this method
again from [SETUP] menu. If "Fail" is still
displayed, try other methods ( 19).
3 Press [OK] on the remote control to
exit the setting.
• "
" is displayed.