Description; Preparation Before Use - SDMO Perform 3000 Manuel D'utilisation Et D'entretien

2. Description

1 Earth connection
2 Oil filler gauge plug
3 Oil draining screw
4 Fuel tank plug
5 Screen filter
1 Oil draining screw
2 Oil filler gauge plug
1 Engine fuel tap
2 Enclosure fixing screw
3 Enclosure locking nuts
1 Air filter cover fasteners
2 Air filter cover
1 Spark arrester fixing screw
1 Spark plug cap

3. Preparation before use

3.1. Positioning the generating set for operation
Choose a site that is clean, well ventilated and sheltered from bad weather.
Place the generating set on a flat, horizontal surface which is firm enough to prevent the set sinking down (under no circumstances
should the set tilt in any direction by more than 10°).
Store the additional supplies of oil and fuel within close proximity, whilst maintaining a certain distance for safety.
3.2. Earthing the generating set
Danger
To connect the set to the ground: Attach a 10 mm
driven 1 meter into the ground.
3.3. Checking the oil level
Before starting the generating set, always check the engine oil level.
Top up with the recommended oil (see § Characteristics) using a funnel, up to the top limit of the gauge.
Important

Remove the oil filler gauge plug (fig. A - No. 2 & fig. B - No. 2) by unscrewing it, and wipe the gauge.

Insert the oil filler gauge plug into the filler neck (fig. B - No. 3) without screwing it, then remove it.

Visually check the level and top up if necessary.

Screw the oil filler gauge plug back fully into the filler neck.

Wipe off excess oil with a clean cloth, check that there are no leaks.
6 Engine fuel tap
7 Air filter
8 Choke
9 Start and stop control
10 Recoil starter handle
3 Filler neck
4 Oil filling plug
4 Enclosure
5 Sediment bowl cover
6 Seal
3 Paper element
4 Foam element
2 Spark arrester
2 Spark plug
The generating sets supply electrical current when in operation: risk of electrocution.
Connect the generating set to the ground at each use.
2
copper wire to the set‟s earth connection and to a galvanised steel earthing rod
Figure A
Figure B
Figure C
Figure D
Figure E
Figure F
11 Circuit breaker
12 Electrical sockets
13 Exhaust silencer
7 Sediment bowl
"Normal" position
5
"Low temperatures" position
6
3 Exhaust silencer protection